EFCO 5XPT Series - Manual (Page 32)

EFCO CORPORATION 2/11/2013 PART NO. YW44 Page 32 of 34
5XPT SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Adjustment Procedures:
17. Adjustment can now be made to the operable panel.
Adjust the rollers so that the operable panel is plumb and true
and will roll smoothly. Adjustment is achieved by extending a
Phillips driver through the hole, above the slot, in the sill end of
the operable panel. Engage the Phillips driver with the roller.
Once engaged with the roller, turn clockwise or counterclockwise
to adjust the roller up or down. (See Fig. 16)
Adjust the lock and keeper so the operable panel will
lock and unlock easily. The lock has two adjustment screws on
the face of the multipoint that allows the locking lugs to move
in and out. (See Fig. 16)
The keeper is mounted with four Pan head fasteners. When
loose, the keeper can move up and down. Align with the multipoint
lock and retighten the fasteners. (See Fig. 17)
Once all adjustments are made, locate supplied hole plugs
and push into each visible hole located at each panel corner.
Fig. 16
Slot
Multipoint
Lock
Keeper
Fig. 17