Page 13 – EFCO T300 Series User Manual
Page 14
Advertising
DOOR REMOVAL
STEP #16 SETTING THE DOOR INTO THE FRAME
SECTION IX: OFFSET PIVOT APPLICATION (CONT.)
PAGE 13
FIGURE #13
DPS/BB JULY 2000
DOOR PORTION
OF PIVOT
PIVOT PIN
PIVOT CAP
FRAME PORTION
OF PIVOT
Remove the pivot caps and retract the pivot pins. Open and tilt the door away from the pivot
jamb to clear the frame pivots.
Use a flat tipped screwdriver to remove the cap from the bottom of the intermediate offset
pivot. Turn the pivot pin counterclockwise to lower the pin. After the pin has been retracted,
rotate the door open to 90˚ and set the door on the bottom pivot. Then, raise the pivot pin
on the intermediate pivot by turning the pivot pin clockwise. See Figure #13.
Advertising
This manual is related to the following products: