EFCO T300 Series - Manual (Page 17)

FIGURE #18
SECTION XIII: CLEARANCE ADJUSTMENTS
STEP #22 MINOR CLEARANCE ADJUSTMENT
PAGE 16
DPS/BB JULY 2000
DOOR WEDGE
Open and support the door with a wedge. Use the wedge to raise the door to the
desired position. With a 7/16" socket and ratchet, turn the jack screw clockwise until
pressure is applied to the glass. To lower the corner, turn the jack screw
counterclockwise. Readjust the wedge and tighten the jack screw until pressure is
applied to the glass. The door can be adjusted again, if required. See Figure #18.
Note: Do not attempt to raise the door by the jack screw. Damage may occur to the
jack screw or door glass. The jack screw is used to hold the glass and door in position.
Use the wedge to raise the door.