Hybrid Racing HR Kswap Cold Air Intake - Manual

Kswap Cold Air Intake
Install Tips:
Features:
 Silicone tube acts as an insulator from
hot air exiting the radiator
 Fits RBC, RRC, RBB, and PRB Plenums
 Works with OEM and big bore throttle
bodies
 Sleek design reduces the number of visi-
ble clamps and brackets once installled
 Anodized 6061-T6 aluminum coupler
tube
Package Contents:
 (1) Silicone Intake Tube
 (1) Aluminum coupling tube
 (1) Hose Clamp Hanger
 (1) Mounting Bracket
 (1) Filter with worm clamp
 (1) 0.5” 3/8”-16 Bolt
 (1) 20mm M10x1.25 Bolt
 (2) M10 Flat Washers
Below you will find tips on how to install your new Hybrid Racing K Swap Cold Air Intake. *This product may
not be legal for highway use. Hybrid Racing is not responsible for any direct or indirect, actual or incidental ex-
pense attributed to the use of any performance parts sold by Hybrid Racing LLC. Purchasers agree to all of the
terms of this agreement upon the purchase of parts. More information can be found at www.hybrid-racing.com.
Install Guide:
This install guide illustrates the key steps and
procedures needed to properly install your new
cold air intake.
Shown to the left is an illustration of most hard-
ware included with this cold air intake. For your
convenience, most of the bolts for the throttle
body have been supplied already threaded into
their proper positions. Refer to this guide if you
remove the bolts and need to determine where
they were intended to go.