Hybrid Racing HR Kswap Cold Air Intake - Manual (Page 8)

Finally, all of the bolts may be tightened to their final torques. First, tighten the t-bolt clamp on the throttle body us-
ing a 10mm deep socket as shown in Figure 12a. Next, tighten the clamp hanger using a flat head screw driver or
a 7/16” socket. The clamp should be tightened within 3-5mm of being fully closed as shown in Figure 12b. Next,
torque the 3/8”-16 bolt on the clamp hanger to 20 ft-lbs using a 9/16” socket as shown in Figure 12c. Finally,
torque the M10x1.25 bolt to 35 ft-lbs using a 17mm socket as shown in Figure 12d.