JDC Electronic SA EasyFlow - Manual (Page 13)

13
MADD Technologies sàrl
– Avenue des Sports 42 – CH-1400 Yverdon-les-Bains – Switzerland
Tel: +41 24 445 31 16 – Fax: +41 24 445 21 23 – Email: [email protected] – www.madd.ch
Data transfer to PC
The data transfer from the device EasyFlow to the PC is done with help of the serial cable furnished with the
device.
Procedure
1. Connect the serial cable to a serial port of the PC and at the connector of the EasyFlow.
2. Launch the application EasyViewer and verify that the configured serial port is the good one.
3. Switch on the device EasyFlow, select the Communication menu with the
button SELECT and press ENTER. The device is now waiting on a
communication from the PC. It is always possible to quit this menu by
pressing SELECT.
4. In the software EasyViewer, select “Load the data from EasyFlow" and click
Ok. The progression of the transfer is showed on the screen of the
EasyFlow. The transfer normally takes only few seconds.
5. Once the transfer terminated, press ENTER to return to the main menu. In case of error, verify the
connection and the serial settings and try again.
If all was done correctly, a window with a graph appears on the PC. For any further question about the use of
the software EasyViewer, please consult the online help of the software