JDC Electronic SA EasyFlow - Manual (Page 9)

9
MADD Technologies sàrl
– Avenue des Sports 42 – CH-1400 Yverdon-les-Bains – Switzerland
Tel: +41 24 445 31 16 – Fax: +41 24 445 21 23 – Email: [email protected] – www.madd.ch
At the end of the calibration, it is still possible to abandon the calibration
procedure by pressing SELECT. If the calibration was done correctly, press
ENTER to save the calibration parameters in non-volatile memory, so these
values will be maintained during the replacement of the batteries.
Remark: Be careful, the operator has only 5 minutes between each operation!