Using the panic alarm, Programming additional transmitters, Transmitter battery replacement – Jeep 2011 Grand Cherokee - Owner Manual User Manual

Page 28

Advertising
background image

then immediately press and hold the UNLOCK button
until the windows lower to the level desired or until they
lower completely.

Using The Panic Alarm

To turn the Panic Alarm feature on or off, press and hold
the PANIC button on the RKE transmitter for at least one
second and release. When the Panic Alarm is on, the
headlights and park lamps will flash, the horn will pulse
on and off, and the interior lights will turn on.

The Panic Alarm will stay on for three minutes unless
you turn it off by either pressing the PANIC button a
second time, or drive the vehicle at a speed of 15 mph
(24 km/h) or greater.

NOTE:

The interior lights will turn off if you turn the

ignition switch to the ACC or ON/RUN position while
the Panic Alarm is activated. However, the exterior lamps
and horn will remain on.

Programming Additional Transmitters

Programming Key Fobs or RKE transmitters may be
performed at an authorized dealer.

Transmitter Battery Replacement

The recommended replacement battery is one CR2032
battery.

NOTE:

• Perchlorate Material — special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/perchlorate

• Do not touch the battery terminals that are on the back

housing or the printed circuit board.

26

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Advertising
This manual is related to the following products: