Kontron CP3003-V - Manual (Page 35)

CP3003-SA Introduction
ID 1052-6929, Rev. 2.0 Page 1 - 15
D R A F T — F O R I N T E R N A L U S E O N L Y
In addition, boards ordered with the ruggedized service comply with the following standards as well.
1.7 Related Publications
The following publications contain information relating to this product.
Table 1-3: Additional Standards for Boards Ordered with Ruggedized Service
TYPE ASPECT STANDARD REMARKS
Environmental Vibration
(Sinusoidal) IEC60068-2-6 Ruggedized version test parameters:
• 10-300 (Hz) frequency range
• 5 (g) acceleration
• 1 (oct/min) sweep rate
• 10 cycles/axis
• 3 axis
Single Shock IEC60068-2-27 Ruggedized version test parameters:
• 30 (g) acceleration
• 9 (ms) shock duration half sine
• 3 number of shocks per direction (total: 18)
• 6 directions
• 5 (s) recovery time
Permanent Shock IEC60068-2-29 Ruggedized version test parameters:
• 15 (g) acceleration
• 11 (ms) shock duration half sine
• 500 number of shocks per direction
• 6 directions
• 5 (s) recovery time
Table 1-4: Related Publications
PRODUCT PUBLICATION
CompactPCI Systems CompactPCI Specification PICMG 2.0, Rev. 3.0
CompactPCI Hot Swap Specification PICMG 2.1 Rev. 2.0
SATA Serial ATA 1.0a Specification
CFast CFast Specification Revision 1.0
XMC ANSI/VITA 42.0-200x XMC Switched Mezzanine Card Auxiliary Standard
ANSI/VITA 42.3-2006 XMC PCI Express Protocol Layer Standard
DisplayPort VESA DisplayPort Standard Version 1.1a
Platform Firmware Unified Extensible Firmware Interface (uEFI) specification, version 2.1
All Kontron products Product Safety and Implementation Guide, ID 1021-9142