Kontron CP3002 uEFI - Manual (Page 33)

CP3002/-RC/-RA uEFI BIOS Security Setup
ID 1042-8946, Rev. 3.0 Page 27
P R E L I M I N A R Y
4. Security Setup
Select the Security tab to enter the Security Setup screen. This screen provides information
about the passwords and functions for specifying the security settings.
The following modes of security are provided:
Note: The CP3002/CP3002-RC/CP3002-RA provides no factory-set passwords.
A p t i o S e t u p U t i l i t y - C o p y r i g h t ( C ) 2 0 0 9 A m e r i c a n M e g a t r e n d s , I n c .
M a i n B o o t S e c u r i t y S a v e & E x i t
Password Description
If ONLY the Administrator’s password is set,
then this only limits access to Setup and is
only asked for when entering Setup.
If ONLY the User’s password is set, then this
is a power on password and must be entered to
boot or enter Setup. In Setup the User will
have Administrator rights.
Administrator Password
User Password
HDD Security Configuration
HDD 0:ST9120822SB

: Select Screen

: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3 Optimized Defaults
F4: Save ESC: Exit
Ve r s i o n 2 . 0 0 . 1 2 0 1 . C o p y r i g h t ( C ) 2 0 0 9 A m e r i c a n M e g a t r e n d s , I n c .
SETTING DESCRIPTION
No password is
set Booting the system as well as entering the Setup is unsecured.
Only Administrator
password is set Booting the system is unsecured.
If no valid Administrator password is entered, only limited access to Setup is provided.
Only User pass-
word is set The password is required for booting the system as well as for entering the Setup menu. On
every startup, the user will be asked for the password.
Both User and
Administrator
passwords are set Booting the system is unsecured.
For entering the Setup, a password is required. If the User password is entered here, lim-
ited access to the Setup is granted. Entering the Administrator password provides full
access to all Setup entries.