Cp3002/-rc/-ra uefi bios the uefi shell – Kontron CP3002 uEFI User Manual
Page 45
CP3002/-RC/-RA uEFI BIOS
The uEFI Shell
ID 1042-8946, Rev. 3.0
Page 39
P R E L I M I N A R Y
com_b:
COM B port configuration
rs232: com_b
port signal level follows the RS-232 standard
[rs422]: com_b
port signal level follows the RS-422 standard
Note: The serial port COM B is available only on the rear I/O.
This option is present only on the CP3002-RC/-RA as the com_b
port signal is fixed to RS-232 on the CP3002.
gbe_a:
GbE A port configuration
[front]: gbe_a
port signal is routed to the front connector
rear: gbe_a
port signal is routed to the rear I/O
Note: This option is not present on the CP3002-RC/CP3002-RA.
gbe_b:
GbE B port configuration
[front]: gbe_b
port signal is routed to the front connector
rear: gbe_b
port signal is routed to the rear I/O
Note: This option is not present on the CP3002-RC/CP3002-RA.
vga:
VGA port configuration
auto: vga
port signals are routed either to the front connector or to the
rear I/O
[front]: vga
port signals are routed to the front connector
rear: vga
port signals are routed to the rear I/O
disabled:
vga port disabled (vga port signals not routed)
Note: “Auto” operation may fail if the monitor cable in use does not
correctly follow the VESA standard. For further information, refer to
the CP3002 User Guide, Chapter “VGA Analog Interface and
Connector J6”.
Note: This option is not present on the CP3002-RC/CP3002-RA as the
vga
port signals are fixed to rear I/O.
wr_prot_eeprom:
System EEPROM write protection
[disabled]:
Do not write protect the system EEPROM
enabled:
System EEPROM is write-protected after POST
wr_prot_sata:
Onboard SATA flash write protection
[disabled]:
Do not write protect the onboard SATA flash
enabled:
The onboard SATA flash is write-protected after POST. OS
needs to be prepared to work with write-protected flash. For further
information, refer to the operating system’s documentation.
wr_prot_spi:
uEFI SPI flash write protection
[disabled]:
Do not write protect the uEFI SPI flash
enabled:
The uEFI SPI flash is write-protected after POST
kboardconfig (continued)