Kontron CP6002 uEFI BIOS - Manual (Page 58)

The uEFI Shell CP6002 uEFI BIOS
Page 52 ID 1039-1612, Rev. 2.0
7.2.2 kboardconfig uEFI Shell Command
kboardconfig
FUNCTION: Configure the non-volatile board settings
SYNTAX:
kboardconfig
kboardconfig [-?|<device>|<setting>]
where:
? Show online help
<device> Specify device from list
<setting> Select configuration type
DESCRIPTION: The kboardconfig command enables the PXE feature or sets the front/
rear I/O configuration of the dedicated device.
Note that many command settings are case sensitive.
USAGE: Show all possible configurations
COMMAND / RESPONSE:
Shell> kboardconfig
Control nonvolatile board settings
Example: kboardconfig
pxe: Select PXE boot network adapter ([disabled] all front_a
front_b rear_a rear_b)
StorageOrom: Launch Storage PCI OpROM (disabled [enabled])
HyperThreading: Enable Hyper Threading technology (disabled
[enabled])
CpuTurbo: Enable CPU turbo mode technology (disabled [enabled])
PrimaryDisplay: Select primary display device ([auto] igd peg pci)
vga: VGA Port Configuration ( auto [front] rear disabled )
SataMode: Determines how SATA controller(s) operate ([ide] ahci
raid
wr_prot_sata: Onboard Sata flash write protection ([disabled]
enabled)
NOTE: CONTACT KONTRON BEFORE USING THIS FUNCTION
wr_prot_eeprom: System EEprom write protection ([disabled]
enabled)
wr_prot_spi: EFI spi flash write protection ([disabled] enabled)
CStates: Enable CPU C-States ( disabled [enabled] )
C1eState: Enable CPU C1e-State ( disabled [enabled] )
C3State: Enable CPU C3-State ( [disabled] enabled )
C6State: Enable CPU C6-State ( [disabled] enabled )
PciCfgDelay: Set Delay for PCI CFG Cycle ( [disabled] 1s 2s 3s 4s 5s )
VgaInterrupt: Enable VGA interrupt generation ( [disabled] enabled )
Show allowed settings e.g. for “PrimaryDisplay”:
Shell> kboardconfig PrimaryDisplay
PrimaryDisplay: Select primary display device
PrimaryDisplay == auto
Allowed options: auto, igd, peg, pci