Kontron RTM806x - Manual (Page 30)

17 RTM806X
www.kontron.com
3. Hot Swap and Installation
3.1 RTM Hot Swap and Installation
Because of the high-density pinout of the hard-metric connector, some precautions must be taken when
connecting or disconnecting a RTM to/from an AT8060:
1- Rail guides must be installed on the enclosure to slide the RTM to the AT8060.
2- Do not force the RTM if there is mechanical resistance while inserting it.
3- Screw the faceplate to the enclosure to firmly attach the RTM to its enclosure.
4- Use extractor handles to disconnect and extract the RTM from its enclosure.
3.1.1 Installing the RTM in the chassis
To install the RTM:
1- Remove the filler panel of the slot.
2- Ensure the RTM is configured properly.
3- Carefully align the PCB edges at the bottom and top card guide.
4- Insert the RTM in the system until it makes contact with the CPU board.
5- Using the ejector handles, engage the RTM in the CPU board connectors until the ejectors are
locked.
6- Fasten screws at the top and bottom of the faceplate.
3.1.2 Removing the RTM from the chassis
To remove the RTM:
1- Unscrew the top and the bottom screw of the faceplate.
2- Unlock the upper handle latch.
3- Wait until the blue LED is fully ON, this mean that the hot swap sequence is ready for RTM removal.
4- Use the ejector to disengage the RTM from the CPU board.
5- Pull the RTM out of the chassis.
WARNING
Always use a grounding wrist wrap before installing or removing the board from a
chassis.