Kontron KTQ45-FLEX - Manual (Page 8)

KTD-00782-I KTQ45 family Page 8 of 92
Introduction
This manual describes the KTQ45/Flex and KTQ45/ATXE boards made by KONTRON Technology A/S. The
boards will also be denoted KTQ45 family if no differentiation is required.
The KTQ45 boards supports the Intel® Core™2 Quad processor Q9000 series, the Intel® Core™2 Duo
processor E8000 and E7000 series with a maximum TDP of 95W. These processors belong to the Intel
Yorkfield and Wolfdale families.
KTQ45 family differences Format PCI RS232 RS485
KTQ45/Flex Flex 2 2 0
KTQ45/ATXE ATX 4 3 1
Use of this Users Guide implies a basic knowledge of PC-AT hard- and software. This manual is focused on
describing the KTQ45 Board’s special features and is not intended to be a standard PC-AT textbook.
New users are recommended to study the short installation procedure stated in the following chapter before
switching-on the power.
All configuration and setup of the CPU board is either done automatically or by the user in the CMOS setup
menus. Except for the CMOS Clear jumper (JBAT1), ME Jumper (JBAT2), SPI jumper (JP6), Interface BIOS
jumper (JP3 and JP5), RS485 mode selection jumper (KTQ45/ATXE only) (JP7&JP9).