Kontron KTQ67-FLEX MED - Manual (Page 45)

KTQ67/Flex -Medical Users Guide
KTD-N0849-D Page 45
Warning: Don’t leave the jumper in position 1-2, otherwise if power is disconnected,
the battery will fully deplete within a few weeks.
6.12 ”Load Default BIOS Settings” Jumper (J11)
The “Load Default BIOS Settings” Jumper (J11) can be used to recover from incorrect BIOS settings. As
an example, incorrect BIOS settings coursing no display to turn on can be erased by the Jumper.
The Jumper has 3 positions: Pin 1-2, Pin2-3 (default position) and not mounted.
To Load Default BIOS Settings:
1. Turn off power completely (no SB5V).
2. Move the Jumper to pin 1-2 for ~10 seconds.
3. Move the Jumper back to position 2-3 (default position).
4. Turn on power (use the Power On Button if required to boot).
5. Motherboard might automatically reboot a few times. Wait until booting is completed.
6.13 ClrRTC (J12)
The ClrRTC (J12) connector is not used and may not be available. Do not install any jumper.
J11
Description
Pin3 Pin2 Pin1
• Default position (same as no function)
• Load Default BIOS Settings
• • • No function
J12
Description
Pin3 Pin2 Pin1
• No function
• Clear ME CMOS settings (same effect as removing Lithium battery for 1 minute)
• • • No function
Internal Connectors
!
Jumper (in Load Default BIOS Settings position) J11 pin 3 J12