9 front panel connector (frontpnl) (j19), Front panel connector (frontpnl) (j19), Internal connectors – Kontron KTHM65-mITX User Manual
Page 46
KTHM65 Users Guide
KTD-N0838-A Page 46
5.9 Front Panel Connector (FRONTPNL) (J19)
Note Pull
U/D
Ioh/
Iol
Type
Signal
PIN
Signal
Type Ioh/
Iol
Pull
U/D Note
-
-
PWR USB6/7_5V
1 2
USB6/7_5V PWR -
-
-
-
USB6-
3 4
USB7-
-
-
-
-
USB6+
5 6
USB7+
-
-
-
-
PWR
GND
7 8
GND
PWR -
-
-
-
NC
NC
9 10
LINE2-L
-
-
-
-
PWR
+5V
11 12
+5V
PWR -
-
- 25/25mA O SATA_LED#
13 14
SUS_LED
O 7mA -
-
-
PWR
GND
15 16
PWRBTN_IN#
I
1K1
4K7
-
I
RSTIN#
17 18
GND
PWR -
-
-
-
PWR
SB3V3
19 20
LINE2-R
-
-
-
-
PWR
AGND
21 22
AGND
PWR -
-
-
-
AI
MIC2-L
23 24
MIC2-R
AI
-
-
Signal
Description
USB10/11_5V 5V supply for external devices. SB5V is supplied during powerdown to allow wakeup
on USB device activity. Protected by resettable 1.1A fuse covering both USB ports.
USB1+/USB1- Universal Serial Bus Port 1 Differentials: Bus Data/Address/Command Bus.
USB3+/USB3- Universal Serial Bus Port 3 Differentials: Bus Data/Address/Command Bus.
+5V
Maximum load is 1A or 2A per pin if using IDC connector flat cable or crimp terminals
respectively.
SATA_LED#
SATA Activity LED (active low signal). 3V3 output when passive.
SUS_LED
Suspend Mode LED (active high signal). Output 3.3V via 470Ω.
PWRBTN_IN# Power Button In. Toggle this signal low to start the ATX / BTX PSU and boot the
board.
RSTIN#
Reset Input. When pulled low for a minimum 16ms, the reset process will be initiated.
The reset process continues even though the Reset Input is kept low.
LINE2
Line2 is second stereo Line signals
MIC2
MIC2 is second stereo microphone input.
SB3V3
Standby 3.3V voltage
AGND
Analogue Ground for Audio
Note: In order to meet the requirements of USB standard, the 5V input supply must be at least 5.00V.
Available cable kit:
PN 821042 Cable Front Panel Open-End, 300 mm
Internal Connectors