Kontron KTQM87-mITX - Manual (Page 59)

KTD-N0886-A Page 57 BIOS - Advanced
KTQM87/mITX Users Guide
ACPI Configuration
Function Selection Description
FACP – KTC S4 Flag Value
Disabled
Enabled Valid Only for ACPI. Controls the value for the RTC
S4 flag in the FACP table.
APIC – IO APIC Mode
Disabled
Enabled
This is valid only for WIN2000, Windows XP. A fresh
install of OS must occur when APIC mode is enabled.
The APIC table will be pointed to by the RSDT, the
Local APIC will be initialized, and the proper enable
bits are set in the PCH.
ALS Support
Legacy
ACPI
Valid only for ACPI. Legacy = ALS support through
the IGD INT10 function. ACPI = ALS support through
an ACPI ALS driver.
EMA Support
Disabled
Enabled
Valid only for ACPI. Controls the EMA device in an
ACPI environment.
MEF Support
Disabled
Enabled
Valid only for ACPI. Controls the Mobile East Fork
feature support in an ACPI environment.
Enabled PTID
Disabled
Enabled Enable/Disable Power and Temperature
Instrumentation Details.
FACP – PM Timer Flag Value
Disabled
Enabled
Valid only for ACPI. Controls the PM Timer Flag
Value in the FACP table.
CPPC
Disabled
Enabled
ACPI 5.0 Collaborative Processor Performance
Control. When CPPC is enabled, the newer ACPI 5.0
method for processor performance control will be
used. When disabled, the older methods (P-State
and T-State) will be used.
CPPC Platform Sci enable
Disabled
Enabled
When enabled, the platform will generate a GPE/SCI
upon CPPC command completion. If disabled, the
OS must poll for command completion.
Native PCI Express
Disabled
Enabled
Native PCI Express Enable/Disable
Phoenix SecureCore Technology Setup
Advanced
ACPI Configuration Item Specific Help
FACP – KTC S4 Flag Value
APIC – IO APIC Mode
ALS Support
EMA Support
MEF Support
Enabled PTID
FACP – PM Timer Flag Value
CPPC
CPPC Platform Sci enable
Native PCI Express
[Enabled ]
[Enabled]
[Legacy]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
Valid Only for ACPI. Controls the
value for the RTC S4 flag in the
FACP table.
F1 Help ↑↓ Select Item +/- Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select ► Sub-Menu F10 Save and Exit