Kontron AM5030 - Manual (Page 26)

Introduction AM5030
Page 1 - 10 ID 1036-3302, Rev. 1.0
P R E L I M I N A R Y
Onboard
Contro
llers
Gigabit Ethernet Intel® 82580EB Quad Gigabit Ethernet PCI Express bus controller with
advanced management features such as serial redirection over LAN:
• Two interfaces routed to front I/O connectors
• Two interfaces routed to the AMC connector
10 Gigabit Ethernet Intel® 82599EB Dual 10 Gigabit Ethernet PCI Express bus controller:
• Two XAUI interfaces routed to the AMC connector
VGA SM750 PCI Express graphics controller
• Supports resolutions of up to 1920 x 1440 pixels
• On-chip 16 MB DDR memory
Serial One 16550-compatible UART routed either to the front I/O (RS-232 signal-
ing) or the AMC connector (3.3V TTL level)
AMC Interconnection
Gigabit Ethernet Common Options Region ports 0-1:
• Two Gigabit Ethernet SerDes ports
Serial ATA Common Options Region ports 2-3:
• Two Serial ATA ports
Extended Options Region ports 12-13:
• Two Serial ATA ports
PCI Express Fat Pipes Region ports 4-7:
• One x4 PCI Express 2.0 port operating at 5.0 GT/s or 2.5 GT/s
XAUI Fat Pipes Region ports 8-11:
• One XAUI-A port
Extended Options Region ports 17-20:
• One XAUI-B port
Debug Extended Options Region port 14:
• One Debug port
Serial Extended Options Region port 15:
• One Serial port
Clock Clock:
• Bidirectional PCI express reference clock (FCLKA)
Connectors
Front Panel
Connectors • Two USB 2.0 ports on 4-pin, type A connectors
• One Serial port (COM1) with RS-232 signal level on RJ-45 connector
• Two Gigabit Ethernet ports on RJ-45 connectors
• One VGA interface on a D-Sub connector
Onboard
Connectors • One SATA extension connector
AMC Card-edge
Connector • One 170-pin AMC Card-edge connector
Switch
DIP Switches Two four-position DIP switches for board configuration
Table 1-2: AM5030 Main Specifications (Continued)
AM5030 SPECIFICATIONS