Kontron AM4140 U-Boot Bootloader - Manual (Page 26)

U-Boot Usage AM4140 U-Boot Bootloader
Page 26 ID 1052-0281, Rev. 1.0
P R E L I M I N A R Y
3.7 sconf Command
sconf
FUNCTION: Provides functions for software-based configuration of external interfaces
available on the AMC Card-edge connector and on the front panel
connectors J2 (GbE B) and J3 (GbE A)
SYNTAX: sconf info|…
select <num>|…
set [<par> <val>]|…
status|…
save [reset]|…
undo|…
where:
sconf command
info option:
displays available configurations
select option:
selects base configuration <num>
<num> parameter:
<0, 1, ... n>
number of base configuration
set option:
indicate or configure parameter for new base configu-
ration
[<par>] parameter:
<…>
parameter for new base configuration
[<val>] value:
<…>
value assigned to parameter
status option:
displays information concerning the status of board
configuration
save option:
saves the current setting
[reset] option:
resets the board after saving the settings
undo option:
ignore current settings and use saved settings again