Kontron AM4140 U-Boot Bootloader - Manual (Page 27)

AM4140 U-Boot Bootloader U-Boot Usage
ID 1052-0281, Rev. 1.0 Page 27
P R E L I M I N A R Y
DESCRIPTION: This command is used to configure external interfaces available on the
AMC Card-edge connector and on the front panel connectors J2 (GbE
B) and J3 (GbE A).
The “sconf info” command shows the possible configurations as well as
the configuration stored in the IPMI Module Management Controller.
The active configuration is indicated in the “sconf status” command.
To configure external interfaces, select a base configuration via the
“sconf select” command. Then, the parameters can be defined more
exactly via the “sconf set” command.
To apply the configuration, invoke the “sconf save reset” command
(“sconf save” command with “reset” option). Only with this command the
configuration will become valid and active.
To determine if a system power cycle is required, invoke the “sconf
status” command.
sconf (continued)