Kontron AM4140 IPMI Firmware - Manual (Page 3)

AM4140 Preface
ID 1051-8188, Rev. 1.0 Page 3
P R E L I M I N A R Y
Table of Contents
1. Introduction ...................................................................................5
1.1 Terminology and Acronym Definitions .......................................................... 5
1.2 Related Publications .................................................................................... 6
1.3 IPMI in AdvancedMC / AdvancedTCA Environment .................................... 6
1.4 Module Management Controller Hardware .................................................. 6
2. MMC Firmware ...............................................................................7
2.1 Key Features ................................................................................................ 7
2.2 Supported IPMI and ATCA Commands ........................................................ 8
2.2.1 Standard IPMI Commands ................................................................... 8
2.2.2 AdvancedTCA and AMC Commands ................................................ 16
3. OEM Commands and Command Extensions ...........................18
3.1 Get Device ID Command with OEM Extensions ........................................ 18
3.2 Set Control State (Firmware Hub, Boot Order) .......................................... 19
3.3 Get Control State (Firmware Hub, Boot Order) .......................................... 20
3.4 OEM Module Quiescence Feedback ......................................................... 21
3.4.1 Usage if a Shutdown Daemon is Announced as Present .................. 22
3.4.2 Usage if no Shutdown Daemon is Announced as Present ................ 22
4. Sensors Implemented on the AM4140 .......................................23
4.1 Sensor List ................................................................................................. 24
4.2 Sensor Thresholds ..................................................................................... 26
4.3 OEM Event/Reading Types ........................................................................ 27
5. Firmware Code ............................................................................29
5.1 Structure and Functionality ......................................................................... 29
5.2 Firmware / Module Identification ................................................................ 29