Kontron AM4140 IPMI Firmware - Manual (Page 8)

IPMI Firmware AM4140
Page 8 ID 1051-8188, Rev. 1.0
P R E L I M I N A R Y
2.2 Supported IPMI and ATCA Commands
2.2.1 Standard IPMI Commands
The following table shows an excerpt from the command list specified in the IPMI specification
2.0. The shaded table cells indicate commands supported by the AM4140 MMC.
M = mandatory, O = optional
Table 3: Standard IPMI Commands
COMMAND
IPMI 2.0
SPEC.
SECTION
NETFN CMD
KONTRON
SUPPORT
ON MMC
IPM DEVICE “GLOBAL” COMMANDS M
Get Device ID 20.1 App 01h M / Yes
Cold Reset 20.2 App 02h O / Yes
Warm Reset 20.3 App 03h O / No
Get Self Test Results 20.4 App 04h O / Yes
Manufacturing Test On 20.5 App 05h O / No
Set ACPI Power State 20.6 App 06h O / No
Get ACPI Power State 20.7 App 07h O / No
Get Device GUID 20.8 App 08h O / No
Broadcast “Get Device ID” 20.9 App 01h M / Yes
BMC WATCHDOG TIMER COMMANDS O
Reset Watchdog Timer 27.5 App 22h O / Yes
Set Watchdog Timer 27.6 App 24h O / Yes
Get Watchdog Timer 27.7 App 25h O / Yes
BMC DEVICE AND MESSAGING COMMANDS O
Set BMC Global Enables 22.1 App 2Eh O / Yes
Get BMC Global Enables 22.2 App 2Fh O / Yes
Clear Message Flags 22.3 App 30h O / Yes
Get Message Flags 22.4 App 31h O / Yes
Enable Message Channel Receive 22.5 App 32h O / Yes
Get Message 22.6 App 33h O / Yes