Kontron AM4150 IPMI Firmware - Manual (Page 31)

AM4150 IPMI Firmware
ID 1052-5679, Rev. 1.0 Page 31
P R E L I M I N A R Y
5.3.2 Firmware Upgrade - “ipmitool hpm”
Firmware upgrade using a HPM.1 file requires at least “ipmitool” version 1.8.10.
The firmware upgrade procedure starts with downloading the HPM.1 file using, for example,
the following command:
The next step is the activation of the newly downloaded MMC firmware. This is done using:
Detailed information about the active firmware image or the inactive image can be obtained
using the commands mentioned below.
To obtain detailed version information of the active MMC firmware, use the following command:
To obtain the version information of the rollback image (only valid if a newly downloaded firm-
ware is already activated), use the following command:
To obtain the version information of the newly downloaded MMC firmware (only valid after
download and before activation), use the following command:
To obtain detailed information about the MMC’s HPM.1 upgrade capabilities, use the following
command:
To perform a manual rollback to the previously good firmware image, use the following com-
mand:
ipmitool hpm upgrade <HPM.1_FWFile>.hpm all
ipmitool hpm activate
ipmitool hpm compprop 1 1
ipmitool hpm compprop 1 3
ipmitool hpm compprop 1 4
ipmitool hpm targetcap
ipmitool hpm rollback