Kontron MSM800SEL - Manual (Page 23)

MSM800SEV/SEL / Quick Start Guide
www.kontron.com 21
4.5 Connect Peripherals to the Board
Prepare the following peripherals:
»
VGA monitor (LCD or CRT) with a resolution up to 1024x768 pixel
»
PS2 keyboard
»
USB mouse
»
LAN cable, if available
»
Hard disk or CompactFlash
»
USB CD drive or floppy drive
»
Power supply with 5 Volts and min. 30 Watts
Make sure the polarity is correct. Otherwise the hard disk and/or electronic board may be destroyed.
1. Connect the VGA monitor to the 15pin high density DSub-connector.
2. Connect the keyboard to the PS/2 connector.
3. Connect the USB mouse to one of the USB connectors.
4. Connect the hard disk with a 44pin cable to the IDE connector.
Alternatively to the hard disk, the CompactFlash card may be inserted into the CF socket.
Pin1 of the cable must go to Pin1 of the connector, which has a red mark next to it (not visible in the photo).
5. Connect a USB CD-Drive or a USB Floppy drive to one of the USB connectors.
6. For the MSM800SEL board only: connect an external RTC 3.6V battery.
Attention! For systems that already have an onboard battery (MSM800SEV): if an external battery is to be
connected, then the onboard battery must be removed first.
7. Insert a boot device: USB stick, floppy, hard disk or bootable CF.