Kontron COMe-bHL6 - Manual (Page 18)

COMe-bHL6 / Product Specification
PEG Configuration
The x16 PCI Express Graphics Port (PEG) is compatible to standard PCI Express devices like Ethernet or RAID controllers.
The COMe-bHL6 supports following PEG Port configuration when used as PCI Express Interface:
» 1Ч16
» 1Ч8
» 1Ч4
» 1Ч2
» 1Ч1
The internal PCI Express controller can be re-configured to support up to 3 PCIe ports on PEG16 interface. The PEG lane
splitting is configurable in setup:
» 1×16 (lanes #0-15)
» 2×8 (lanes #0-7 + #8-15)
» 1Ч8 + 2Ч4 (lanes #0-7 + #8-11 + #12-15)
With splitted ports, Port2 (#8-15 or #8-11) and Port3 (#12-15) cannot have more lanes
active as Port1 (#0-7) has
Storage
onboard SSD -
SD Card support -
IDE Interface -
Serial-ATA up to 3x SATA 6Gb/s, 1x SATA 3Gb/s
SATA AHCI NCQ, HotPlug, Staggered Spinup, eSATA, PortMultiplier
SATA RAID 0, 1, 5, 10 (QM87 only)
If SATA AHCI or RAID is disabled in setup, the SATA Interface only supports 3Gb/s transfer
rate and Staggered Spin-Up. To configure a RAID Setup connect at least two hard drives
and enable RAID support in BIOS Advanced/HDD Settings. After reboot, setup your RAID
configuration in the new setup item “Addon Devices”
18