Kontron ETX miniBaseboard - Manual (Page 15)

8 Dual Ethernet
Kontron User's Guide ETX miniBaseboard 15
8 Dual Ethernet
8.1 Ethernet1 - ETX® Ethernet
Ethernet1 connector is placed in Combiconnector1 and connected to ETX® Module.
LAN LED activity on Combiconnector1:
➤ Activity LED green = RX/TX activity
➤ Link LED yellow = Link up
LED D5 activity on ETX miniBaseboard:
➤ Speed LED D5 off = 10Mbps
➤ Speed LED D5 green = 100Mbps
8.2 Ethernet2 - onboard Gigabit LAN
Ethernet2 connector is placed in Combiconnector3 and connected to onboard Gigabit LAN Controller
Intel82541EI. Please take into consideration that you may need a special driver from Intel for this
controller. The driver can be found in the download section for ETX miniBaseboard on Kontron’s
Webpage. This device is PCI device slot 1.
LAN LED activity on Combiconnector3:
➤ LED1 green = Link up
➤ LED1 blinking = RX/TX activity
➤ LED2 off = 10Mbps
➤ LED2 yellow = 100Mbps
➤ LED2 green = 1000Mbps