Kontron ETX miniBaseboard - Manual (Page 8)

3 Short description
Kontron User's Guide ETX miniBaseboard 8
3 Short description
The following short description is intended to convey a brief overall view of the components. Installation
alternatives are depicted herein. Only special non-standard PC functions are explained, as information
of all other interfaces is commonly available.
Summary of all available interfaces:
Connector Description
Feature connector Kontron 24pin standard connector for additional features
IDE1
Primary Master (CF-Slot, e.g. as bootdevice)
Primary Slave (2.54mm, 40pin connector)
IDE2 Secondary Master/Slave (2.00mm, 44pin connector)
LPT1 25 pol. SUB-D connector, combiconnector 2
COM1 9 pol. SUB-D (V.24), combiconnector 2
COM2 10 pol. 2.54 mm connector (V.24)
COM3 10 pol. 2.54 mm connector
COM4 10 pol. 2.54 mm connector
VGA 15pl. SUB-D, combiconnector 2
Flat panel interface JILI(D)-FFC-Connector (ETX board dependend)
USB1 Combiconnector 1
USB2 Combiconnector 1
USB3 Combiconnector 3
USB4 Combiconnector 3
Ethernet 1 10/100 Mbit, combiconnector 1
Ethernet 2 10/100/1000 Mbit, combiconnector 3
PS/2 PS/2 - Keyboard & Mouse
PCI Slot
PCMCIA/Cardbus Slot via external controller PCI1520
Audio Out 3.5mm jack
Audio In 3.5mm jack
Notes: * To protect external power lines of peripheral devices, make sure that:
- the wires have the right diameter to withstand the maximum available current
- the enclosure of the peripheral device fulfils the fire-protection requirements of IEC/EN60950