Kontron CP305 - Manual (Page 25)

CP305 Introduction
ID 1035-7168, Rev. 2.0 Page 1 - 5
P R E L I M I N A R Y
1.3 Optional Modules
1.3.1 CP305-HDD Module
The CP305-HDD module for the 8 HP CP305 version provides legacy PC I/O ports. It includes
one digital DVI port, two USB 2.0 ports, one COM port, a PS/2 keyboard and mouse port, one
IDE connector, and one CompactFlash socket. A SATA hard disk interface is also available for
mounting a 2.5” hard disk drive.
For further information concerning the CP305-HDD module, refer to Appendix A.
1.3.2 CP305-TR Module
The Kontron CP305-TR module for the 8 HP CP305 version has been designed for use in
mobile- and transportation-oriented applications where robust, mechanically secured
connections are required. It includes two Fast Ethernet ports via M12, D-coded connectors, two
USB 2.0 service ports via M8, A-coded connectors and three GPO LEDs on the front panel as
well as two onboard COM ports, one onboard GPIO port, one CompactFlash socket, two
onboard SATA ports for connection to external SATA devices and one CompactPCI connector
for connecting the CP305-TR to the backplane.
For further information concerning the CP305-TR module, refer to Appendix B
1.3.3 CP-RIO3-04 Rear I/O Module
The CP-RIO3-04 rear I/O module has been designed for use with the CP305 board from
Kontron and provides comprehensive rear I/O functionality.
For further information concerning the CP-RIO3-04 rear I/O module, refer to Appendix C.
1.4 System Relevant Information
The following system relevant information is general in nature but should still be considered
when developing applications using the CP305.
Table 1-1: System Relevant Information
SUBJECT INFORMATION
System Configuration The CP305 system controller board can support up to 7 peripheral boards with 32-
bit and 33 MHz.
Master/Slave Functionality The CP305 can operate only as a master board.
Board Location in the System The CP305 board must be installed in a system slot of a CompactPCI backplane.
Hot Swap Compatibility The CP305 supports the addition or removal of other boards whilst in a powered-
up state. Individual clocks for each slot and ENUM signal handling are in compli-
ance with the PICMG 2.1 Hot Swap specification.
Hardware Requirements The CP305 can be installed in any CompactPCI 3U rack.
Operating Systems There are various operating systems available for the CP305. For detailed infor-
mation, please contact Kontron.