Kontron CP305 - Manual (Page 30)

Introduction CP305
Page 1 - 10 ID 1035-7168, Rev. 2.0
P R E L I M I N A R Y
Interfaces
CompactPCI Compliant with CompactPCI Specification PICMG® 2.0 R 3.0
• System master operation
• 32-bit / 33 MHz master interface
• 3.3 V or 5 V (universal PCI interface)
Rear I/O The following interfaces are routed to the Rear I/O connector J2:
• COM1 and COM2 (3.3V TTL signaling)
• 2 x USB 2.0
• VGA (analog)
• 2x Gigabit Ethernet
• 2x SATA
• System Management signals
• General Purpose signals
Hot Swap The CP305 is not hot-swappable but supports the addition and removal of
other boards whilst in a powered-up state. Individual clocks for each slot and
Enum signal handling are in compliance with the PICMG 2.1 Hot Swap
Specification.
VGA Built-in Intel 3D Graphics accelerator for enhanced graphics performance.
• Supports resolutions of up to 2048 x 1536 at a 75 Hz refresh rate
• Hardware motion compensation for software MPEG2 decoding
• Dynamic Video Memory Technology (DVMT3.0)
Gigabit Ethernet Two 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on the Intel® 82574L Ethernet PCI Express bus controller individually
switchable to front or read I/O
• Dual RJ-45 connector on the front panel
• Automatic mode recognition (Auto-Negotiation)
• Automatic cabling configuration recognition (Auto MDI, MDI-X)
Cabling requirement: Category 5, UTP, four-pair cabling
USB Six USB ports supporting UHCI and EHCI:
• Two USB 2.0 connectors on the front panel
• Two USB 2.0 connectors on the front panel of the 8 HP version
• Two USB 2.0 connectors on the rear I/O interface
Serial Two UARTs, 16C550 compatible.
• COM1 available either on the front panel of the 8 HP version or on the
Rear I/O
• COM2 available on Rear I/O only
Keyboard and Mouse Keyboard and Mouse are supported
• USB keyboard support on 4HP and 8HP
• PS/2 only with CP305-HDD module (8HP)
Table 1-2: CP305 4HP Version Main Specifications (Continued)
CP305 SPECIFICATIONS