Light s and winds hield wiper s, Exterior lighting – Mercedes-Benz S-Sedan 2015 Owners Manual User Manual

Page 147

Advertising
background image

The hazard warning lamps automatically

switch on if:

R

an air bag is deployed or

R

the vehicle decelerates rapidly from a

speed of above 45 mph (70 km/h) and

comes to a standstill

The hazard warning lamps switch off auto-

matically if the vehicle reaches a speed of

above 6 mph (10 km/h) again after a full

brake application.
The hazard warning lamps still operate if the

ignition is switched off.

Cornering light function

The cornering light function improves the illu-

mination of the road over a wide angle in the

direction you are turning, enabling better vis-

ibility in tight bends, for example. It can only

be activated when the low-beam headlamps

are switched on.
Active:

R

if you are driving at speeds below 25 mph

(40 km/h) and switch on the turn signal or

turn the steering wheel

R

if you are driving at speeds between

25 mph (40 km/h) and 45 mph (70 km/h)

and turn the steering wheel

The cornering lamp may remain lit for a short

time, but is automatically switched off after

no more than three minutes.

Adaptive Highbeam Assist PLUS

General notes

With Adaptive Highbeam Assist Plus, you can

automatically switch between low-beam, par-

tial high-beam and high-beam headlamps.
Partial high-beam is a form of illumination

whereby the high-beam is directed past other

road users. Other road users are kept out of

the high-beam. This prevents glare. When

there is a vehicle in front, for example, the

high-beam headlamps illuminate the areas to

its right and left, and the vehicle in front is

illuminated by the low-beam headlamps.
The system automatically adapts the low-

beam headlamp range depending on the dis-

tance to the other vehicle. Once the system

no longer detects any other vehicles, it reac-

tivates the high-beam headlamps.
If the high-beam or partial high-beam are

causing too much reflection from traffic

signs, the lights are automatically dimmed

and glare for the driver caused by the reflec-

tions is thus avoided.
The system's optical sensor is located behind

the windshield near the overhead control

panel.

Exterior lighting

145

Light

s

and

winds

hield

wiper

s

Z

Advertising