Vermont Casting thru 3379 - Manual (Page 5)

5
Radiance Vent-Free Gas Heater
20004555
Clearance Requirements
Minimum Clearances to
Combustible Materials
Maintain clearance, (empty space), between combus-
tible materials and the heater as specified below.
Hearth Requirements
The Radiance Unvented heater must be installed on
rigid flooring. If the appliance is installed on any com-
bustible surface other than wood flooring, such as
carpet or tile, a metal or wood panel must be installed
to extend the full length and width of the unit. There are
no other hearth or floor protection requirements.
Fig. 3 Minimum mantel clearance.
FP599b
JUV
stove mantel heights
9/21/00 djt
A
B
C
D
E
V
W
X
Y
Z
Mantel Mantel from
Ref. Shelf Depth Ref. Stove Top
A 7¹⁄₂” (190mm) V 16” (406mm)
B 6” (152mm) W 14¹⁄₂” (368mm)
C 4¹⁄₂” (114mm) X 13” (330mm)
D 3” (75mm) Y 11¹⁄₂” (292mm)
E 1¹⁄₂” (38mm) Z 10” (254mm)
ST694
Wall
ST103a
Min. Clrnc
11/12/99 djt
B B
D
A
C
A: Maximum Alcove Depth ...............24” (609mm)
B: To Side Wall ...................................4” (101mm)
C: To Rear Wall ................................. 4” (101mm)
D: To Ceiling ...................................60” (1524mm)
Alcove Clearances
ST103a
ST101
Min. Freestanding Clrnc
4/15/99 djt
B A
A: To Side Wall / Trim*......................... 4” (101.6mm)
B: To Rear Wall ................................... 4” (101.6mm)
ST101
Fig. 2 Minimum wall clearances.
• Do not install this heater in a bathroom or bed-
room.
• Installation of this heater must conform with local
codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54.
• This heater creates warm air currents. These
currents move heat to wall surfaces next to the
heater. Installing the heater next to vinyl or cloth
wall coverings or operating the heater where im-
purities in the air such as tobacco smoke exist,
may discolor walls.
• Do not use a blower insert, heat exchanger
insert or other accessory not approved for use
with this heater.
WARNING