Miller Cineline 70 - Manual (Page 10)

10
Unlock Lock
3mm Hex Key
Counter
Clockwise
Clockwise
Operating Instructions
4 Camera Plate Lock Adjustment
The Camera Plate Lock is designed to secure the
CAMERA PLATE in a set position. The Cineline 70 BASE
PLATE can accept a third party (Arri type) CAMERA
PLATE, however, the Camera Plate Lock may need to be
adjusted to account for small dimensional variations in
third party CAMERA PLATES that can significantly affect
the locking function.
4.1 Press and hold the SAFETY RELEASE KNOB then pull the
SIDE LOAD LOCK LEVER outwards.
4.2 With the CAMERA PLATE in place, gently push the
SIDE LOAD LOCK LEVER towards the BASE PLATE until
resistance is felt – this is the start of the locking action.
Check the position of the SIDE LOAD LOCK LEVER as
shown in figure 9.
4.3 Adjustment is necessary if the SIDE LOAD LOCK LEVER
position is outside the recommended range. Follow figure
9 to determine the correct method of adjustment.
Fig. 8
Flat Screwdriver