Miller Cineline 70 - Manual (Page 11)

11
4.4 Using a 3 mm Hex key unlock the LOCK SCREW (fig. 6),
then using a broad flat screw driver turn the ADJUSTING
SCREW (fig. 6) in the direction shown by 1/8 of a turn
and re-check step 4.2, repeat 4.4 if necessary. When
adjusted correctly, the SIDE LOAD LOCK LEVER will be
smooth to operate and require modest effort to lock the
CAMERA PLATE.
4.5 Once the correct adjustment is achieved, remove the
CAMERA PLATE and lock the LOCK SCREW.
Fig. 9
Turn Adjustment Screw
Counterclockwise to
compensate for a wider
camera plate.
Camera Plate
Correct position of Side
Load Lock Lever at the
start of locking action.
Camera Plate
Turn Adjustment Screw
Clockwise to compensate
for a narrower camera plate.
Camera Plate