Oldcastle BuildingEnvelope Solar Eclipse - Manual (Page 10)

10 


S U N C O N T R O L - I N S T A L L A T I O N M A N U A L
Louver
Cut Length
FIGURE 9
Outriggers
FS-20 (#10 X 1/2" S.S. button socket head B pt)
fastener. (4) required typical per louver.
Custom designs may vary.
3.1 Fabrication
15) All standard sunshade outriggers are factory drilled for attachment to shade louvers
16) Cut louvers to fit between outriggers per formulas shown on FIGURE 9.
SOLAR ECLIPSE TM
Fabrication Notes:
enterline minus 11/16" or mull
centerline minus anchor (1/4" std.) minus 3/8" (thickness of two
1) Louver Cut Length = Mull c
standard outriggers) minus 1/16" clearance.
2) Each louver attached to outriggers with (4) FS-20 fasteners.
Custom louvers may require additional fasteners.
3) Note: Number of louvers will vary based on sunshade depth
and project requirements.