16_shelf – Oldcastle BuildingEnvelope Solar Eclipse User Manual
Page 16
16
S U N C O N T R O L - I N S T A L L A T I O N M A N U A L
SOLAR SHELF
™
SS-114
Wall Mount
SS-115 Panel Retainer
Cut length equals shelf
strut centerline minus 2 5/8".
Drill 7/32" holes at maximum
12" o.c. Locate on upper &
lower "V" grooves.
1/2"
1/2"
FIGURE 18
12" O.C.
TYP.
Short leg of wall mount
to top of horizontal
NOTE: WALL MOUNT IS
HANDED AND MUST BE
ORIENTED AS SHOWN.
4.5 Fabricate anchor holes in SS-114 wall mount and the SS-115 panel retainer. Two rows of 7/32" dia.
holes should be drilled between each strut at 12" on center or as required by engineer's review.
Holes should be located in SS-115 at 1/2" from both ends. Take care to align holes in both
extrusions. See FIGURE 18.