Oldcastle BuildingEnvelope PW-180 - Manual (Page 3)

JULY 2011 2
Phone: 1-866-OLDCASTLE (653-2278)
Web Address: www.oldcastlebe.com
1.
A). OBTAIN BENCH MARKS AT EACH
JAMB (4’0” FROM FINISHED FLOOR)
FROM GENERAL CONTRACTOR.
B). CHECK OPENING FOR WIDTH
AND HEIGHT.
C). CHECK JAMBS FOR PLUMB.
A). DOUBLE CHECK SHIPMENT BY
2.
LAYING OUT TRACK & ACCESSORIES
IN ACCORDANCE WITH ASSEMBLY
PRINT AND ACCESSORY LISTS.
B). TAILS OF TOP SWITCH MUST FACE
SAME DIRECTION AS FLOOR SWITCH.
A). LOCATE THE START OF SWITCH ON
SHOP DRAWING OR DATA SHEET.
3.
B). ESTABLISH DIMENSION OF TRACK
CENTER LINE TO LOCK JAMB ON SHOP
DRAWINGS OR DATA SHEET. C). INSTALL
FLOOR SWITCH AND TRACKS STARTING AT THE
“START OF SWITCH POINT AND LOCK JAMB. D).
SET TOP OF TRACK WITH FINISHED FLOOR AND
LEVEL WITHIN 1/8” – USE TRANSIT OR WATER
LEVEL AND LEVELING WEDGES. E). PACK
QUICK DRYING CEMENT AROUND ALL TRACK
ANCHOR STRAPS AND SWITCHES. F). DO NOT
SET PANELS UNTIL CEMENT IS HARD.
A). INSTALL TOP TRACK LEVEL AND
4.
PLUMB WITH BOTTOM TRACK.
B). USE A STORY POLE TO HOLD
VERTICAL OPENING DIMENSION
TO +1/4” TO –0”.
P W - 9 0 S L I D I N G M A L L F R O N T
I N S T A L L A T I O N I N S T R U C T I O N S