Oldcastle BuildingEnvelope PW-180 - Manual (Page 7)

JULY 2011 6
Phone: 1-866-OLDCASTLE (653-2278)
Web Address: www.oldcastlebe.com
5.
TO INSTALL PANELS, REMOVE THE TWO
4” SECTIONS OF THE TOP TRACK.
INSERT BACK TAB IN GROOVE ON SAME SIDE
6.
AS SWITCH TAILS.
INSERT TAB IN LEAD EDGE OF PANEL IN
GROOVE OPPOSITE THE SWITCH TAILS.
MAKE SURE TOP TABS ARE INSTALLED THE
SAME WAY.
INSTALL PANELS AS NUMBERED ON SHOP
7.
DRAWINGS OR DATA SHEET.
INSTALL PANELS WHERE 4” TRACK SECTIONS
WERE REMOVED
WITH THE FIRST PANEL INSTALLED, CHECK
SWITCH LAYOUT.
– PANEL SHOULD GO IN AND OUT OF
SWITCH FREELY.
– PANEL IN SWITCH SHOULD BE PARALLEL
TO THE STRAIGHT TRACK.
A). USE PRY BAR TO LIFT WEIGHT FROM ROLLER.
8.
B). INSERT WEDGE UNDER PANEL.
C).REMOVE ROUND PLASTIC COVER.
D). BACK OFF SET SCREW.
E). TO MOVE UPWARD, ROTATE BUSHING
CLOCKWISE WITH STANDARD SCREWDRIVER.
RE-TIGHTEN SET SCREW.
REPLACE PLASTIC COVER
BOTTOM CLEARANCE IS PRE-SET AT 3/8” (ADJUSTABLE
UP TO 1/2”). TOP CLEARANCE IS 1/4” TO 3/8”.
CHECK ALIGNMENT OF ALL COMPONENTS AND
9.
FILE ALL TRACK JOINTS SMOOTH.
LUBRICATE GROOVES IN ALL TRACK AND
SWITCHES WITH JOHNSON’S #140 WAX STICK
PROVIDED IN ACCESSORY BAG.
RECHECK FREE MOVEMENT OF ALL PANELS.
P W - 1 8 0 S L I D I N G M A L L F R O N T
I N S T A L L A T I O N I N S T R U C T I O N S