Clarion DXZ378RMP - Manual (Page 11)

English
11
DXZ378RMP/DXZ379RMP
5. OPERATIONS
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “ CONTROLS ” on page ii (unfold).
Basic Operations
CAUTION
Be sure to lower the volume before
switching off the unit power or the ignition
key. The unit remembers its last volume
setting. If you switch the power off with the
volume up, when you switch the power back
on, the sudden loud volume may hurt your
hearing and damage the unit.
Turning on/off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car’s
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [ SRC ] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [ SRC ] button for 1
second or longer to turn off the power for the
unit.
Note:
• The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power is
turned on, the “
SYSTEM CHECK ” appears in the
display. The system check starts within the unit.
When the system check is complete, press the
[
SRC ] button again.
Selecting a mode
1. Press the [ SRC ] button to change the
operation mode.
2. Each time you press the [ SRC ] button, the
operation mode changes in the following
order:
Radio ➜ (DAB) ➜ CD/MP3/WMA ➜ (iPod
BB) ➜ (CD changer) ➜ (DVD changer) ➜
(TV) ➜ AUX ➜ Radio...
∗ External equipment not connected with
CeNET is not displayed.
Adjusting the volume
1. Turning the [ ROTARY ] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
∗
The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
Press the [ DISP ] button to select the desired
display.
∗
Once selected, the preferred display becomes
the display default. When a function
adjustment such as volume is made, the
screen will momentarily switch to that
function’s display, then revert back to the
preferred display several seconds after the
adjustment.
∗ For information on how to enter a title, refer to
the subsection “
Entering titles ” in section
“ Operations Common to Each Mode ”.
∗ When CT data is not received, “ CT– –:– – ”
appears in the display.
DXZ378RMP_EN.book 11 ページ ２００６年１１月２７日 月曜日 午後２時２２分