Pizzacraft PM6000 Pizzeria Pronto Outdoor Pizza Oven - Manual (Page 12)

12
oPerAtING INstrUCtIoNs
bReaking in youR oven
When firing your oven for the first time, it is advisable to run the burner on “High” for 20 minutes and
then turn the oven off and let cool to room temperature. This tempers the oven and once cool is ready
for use. Note that each burner has been tested before it left the factory, discoloration of the metal is a
natural result of the material being heated.
Remove for
Auxiliary
Lighting
oven ligHting instRuctions
to Light the burner:
1. Make sure the control knob is in the “OFF”
position.
2 . Make sure chimney vent in the hood is unob-
structed and rain cover is removed.
3. Open the LP (liquid propane) Gas tank valve.
4. Push the control knob in and turn to the left to
“HIGH” position until it clicks. Repeat quickly for
5 seconds until burner lights.
5. If the burner does not ignite within 5 seconds,
immediately turn control knob back to “OFF”
position. Wait 5 minutes and repeat step 4 again.
6. If the burner still does not ignite, TURN OFF
THE GAS. WAIT 5 MINUTES for excess gas to
dissipate.
7 . If the burner still can’t be lit, refer to the Trouble-
shooting section.
8. If the burner flame is accidentally extinguished
during cooking repeat steps 1-7.
9. Keep the tank valve closed when not in use.
auxiliaRy ligHting instRuctions
to light the burner:
1. Make sure the control knob is in the “OFF” posi-
tion.
2 . Remove the hood and two baking stones and set
aside. If oven is hot from previous cooking use
extreme caution handling oven components. Use
heat resistant gloves and place components on a
heat resistant surface.
3 . Open the LPG tank valve.
4. Remember to keep face and hands away from
burner area.
5. push the control knob in and turn the knob
to the [left] to “HigH” postion until it clicks.
Repeat quickly for 5 seconds until the burner
lights.
6 . Once lit set burner to low and using heat resistant
gloves replace stones and hood in place. Return
knob to high for preheating.
7 . If the burner does not ignite within 5 seconds,
immediately turn control knob back to “OFF”
position. Wait 5 minutes and repeat step 5 again.
8 . If the burner still does not ignite, TURN OFF
THE GAS. WAIT 5 MINUTES for excess gas to
dissipate.
9 . If the burner still can’t be lit, refer to the Trouble-
shooting section or call customer service at 1-800-
521-0505.
10. Keep the tank valve closed when not in use.