Pizzacraft PM6000 Pizzeria Pronto Outdoor Pizza Oven - Manual (Page 9)

9
INstALLAtIoN INstrUCtIoNs
WArNING
WArNING
Do not attempt to operate your oven on other gases. Failure to follow this warning could lead to a
fire hazard and bodily harm. Doing so will void your warranty.
The Type 1 connective coupling supplied with
your oven must not be replaced with a different
type of oven/tank connection system. Removal
could result in loss of warranty, gas leakage,
fire, and severe bodily harm. Doing so will void
your warranty.
The propane tank valve connection supplied
with this oven incorporates four important safe-
guards: Hand Assembly, Hand Disassembly,
Excess Flow Control, and Temperature- Acti-
vated Shut-Off.
a. HanD assembly
1. Make certain the tank valve and all the appliance
valves are in the “OFF” position.
2. When connecting the regulator/burner valve as-
sembly to the tank valve, turn the large
plastic nut clockwise until it stops.
3. Gas will not flow unless the plastic nut is com-
pletely connected.
4. HAND TIGHTEN ONLY.
b. HanD Disassembly
1. Make certain the tank valve and all the appliance
valves are in the “OFF” position.
2. Turn the large plastic nut counter-clockwise until it
is disassembled.
3. HAND LOOSEN ONLY.
For Portable Liquid Propane -Gas Connection
Gas requirements:
the oven is set and tested at the factory for use with LP gas only.
c. excess FloW contRol
The propane regulator assembly incorporates an ex-
cess flow device designed to supply the oven with suf-
ficient gas flow under normal conditions yet control
excess gas flow. Rapid changes in pressure can trigger
the excess flow device providing a low flame and low
temperature. If the tank valve is turned open to allow
gas flow while a burner valve is open, the surge of
pressure will cause the device to activate. The device
will remain closed until the pressure is equalized.
This should occur within 5 seconds. To ensure this
does not cause difficulty in lighting the oven, follow
these instructions:
1. Make sure the burner valve is “OFF”.
2 . Close and reopen the tank valve slowly and wait
5 seconds.
3. Follow step 4 of lighting instructions (pg. 12)