ProgressiveRC 8 PowerLab User Manual

Page 83

Advertising
background image

Bananas Removed

The bananas were removed when charging

Negative Amps

Check the supply wiring

Chg. Not Allowed

The preset will not allow charging

Cell V. Too Hi/L

The cell voltage is out of range

Pack Below 3.0V

The pack voltage is too low. Check the preset Flag Bad Pack setting

REPLACE BAD PACK

Check the preset Flag Bad Pack setting

Exp. Ch Com. Err

Check that all the chargers have a good common ground

Safety Code #78

High voltage when off

Safety Code #79

CH1CELLS out of range

Safety Code #80

Regenerative voltage setting is corrupt

Safety Code #81

CHSNUMBER stuck in loop

Safety Code #82

Amps out of range

Safety Code #83

Supply low volt setting is corrupt

Safety Code #84

Regen and charge enabled

Safety Code #85

Amps negative in charge

Safety Code #86

Amps positive in discharge

Safety Code #87

Regen with no discharge

Safety Code #88

AMPSDSCHRANGE in charge mode

Safety Code #89

Supply battery has changed

Safety Code #90

Unknown screen number

Safety Code #92

Mux number error

Safety Code #93

Calibration checksum bad. Send charger to factory

Safety Code #94

Bad EEPROM write

Safety Code #95

Bypass Over-volt Check node wiring or selected node wiring

Safety Code #96

PWM ratio too high. Check the power supply and output wiring

Safety Code #97

Amps were not read on startup

Safety Code #98

P_RAMPRESET not master

Safety Code #99

Bad mode number

Safety Code #100

Temperature out of range

Safety Code #105

Preset not factory validated

Safety Code #106

Preset number out of range

Safety Code #107

Charge timeout out of range

Safety Code #108

Preset loaded while charging

Safety Code #109

Charge termination unknown

Safety Code #110

Expansion channel found in mode 30

Safety Code #111

Preset cell over volts too high

Safety Code #112

MEASUREDDUTY16 > 1024

Safety Code #113

Charge PWM not regulating

Safety Code #114

Bad preset flash check while running

Safety Code #115

Bad preset flash checksum on start

Safety Code #116

Bad preset ram checksum on start

Safety Code #117

Bad segment checksum on start

Safety Code #118

Bad segment checksum while running

83

Advertising