0 weighing, 1 weigh in, Weighing – Rice Lake 920i Based Truck In/Out System User Manual
Page 18
14
920i Based Truck In/Out Weigh Program
4.0
Weighing
4.1
Weigh In
The general weigh-in procedure is as follows:
1. The truck moves onto the scale for weigh-in.
2. Press the
Weigh In
softkey. The following screen is displayed.
Figure 4-1. Weigh In Screen
3. Enter the truck ID by using the numeric keys on the 920i. Press
enter
to save the ID number.
If the truck ID has already been entered and a weigh in has already been complete, the following error message
appears on the user screen:
“Error, Truck is Weighed In.”
4. Enter the Customer ID, Product ID, and Project ID as the series of prompts come up.
Press enter without keying in an ID for any of the above as it is not necessary to enter those. If Auto-prompt is
set to No in the Supervisor System menu this will not prompt through all IDs and the user will have to press
individual softkeys to select customer, project, product IDs separately.
5. After valid truck IDs are entered the following screen is displayed.
Figure 4-2. Truck ID Data
Home
Product
10/22/07
08:05AM
SCALE #1
-888.8888
Mode
Units
End
Scale
#1
Truck
Tare
Gross
Customer
Product
Net
Customer
Project
Project
Select
Enter Truck ID
Note
Note
Cancel
Customer
10/22/07
08:05AM
SCALE #1
-888.8888
Mode
Units
Complete
Scale
#1
Truck
Tare
Gross
Customer
Product
Net
Project
Product
Project