0 weigh – Rice Lake 920i Custom Grain Program User Manual
Page 5
2
920i Grain Program
2.0
Weigh
The actual weighing operation is done using the
Weigh
softkey. The following steps explain the actual truck
weighing operation.
1. After a truck pulls onto the scale, the operator
presses the
Weigh
softkey. The 920i indicator
prompts the operator to
Enter Truck ID
.
2. The operator enters the truck ID followed by
the
Enter
key located on the 920i navigation
keypad.
Figure 2-1. 920i Navigation Keys
3. If the ID is new, then the weigh in weight is
printed out of port #1.
4. If the ID is located, then the operator is
prompted to
Enter Grain No.
on the 920i
screen (shown below).
Figure 2-2. Enter Grain Number
Key in the grain number and press the
Enter
key on the navigation keypad. If the grain is
not valid the indicator prompts,
Not Defined,
Re-Enter
.
5. If the grain is valid, the operator is prompted
to
Enter% Shrink
.
Figure 2-3. Percentage of Shrink
Key in the shrink percentage followed by the
Enter
key.
6. The operator is prompted to
Enter% Dockage
.
Figure 2-4. Percent Dockage
Key in the dockage percentage followed by
the
Enter
key.
7. The operator is prompted to
Enter% FM
.
Figure 2-5. Percent Foreign Material