Rice Lake 920i Panel Mount - Manual (Page 2)

2 920i Panel Mount Installation Instructions
Installation
Use the dimensions shown in Figure 1 to lay out the panel cutout for the panel mount enclosure. See Figure 2 on
page 2 for enclosure dimensions.
Figure 2. Panel Mount Enclosure Dimensions
Once the cutout has been prepared, slide the enclosure into the cutout from the front of the panel. Slide on the
reinforcing plate (PN 87608) and finally slide the clinching bracket around the enclosure from inside the panel.
Secure the bracket to the enclosure using the six 1/4" screws provided in the parts kit (PN 71522), then use the nine
1-1/2" screws (PN 82425) to secure the clinching bracket to the panel door. See Figure 3.
Reinforcing Plate
Clinching Bracket
Figure 3. Clinching Bracket Assembly