Rice Lake Bariatric Handrail with Chair Seat (250-10-4) - Technical Instructions - Manual (Page 7)

Bariatric Handrail Scale Technical Manual - Scale Assembly 3
3.0 Scale Assembly
3.1 Unpacking Your Scale
Place the unopened box in an open area that has ample room for unpacking the scale.
Parts contained in the shipping box include:
• The scale
• This manual
• Six AA batteries
• 6 mm Allen Key
3.2 Repacking
If the Digital Bariatric Handrail Scale must be returned for modification, calibration or repair, it must be properly
packed with sufficient packing materials. Whenever possible, use original carton when shipping the scale back.
Important
Damage caused by improper packaging is not covered by the warranty.
3.3 Setting Up Your Scale
Use the following steps to set up the Digital Bariatric Handrail Scale with seat.
1. Locate the manual from inside the box and set aside as it will provide instructions on the proper scale
removal and set up.
2. Move the scale into the area where the weighing process will occur. It’s recommended to place the scale
on a hard, level surface for the most accurate weighments. Thin carpeting is fine but not recommended.
3. Using two people, remove the scale out of the packaging material that it came in by lifting the scale out
of the box by the scale base.
Note
DO NOT lift the scale out of the box by its handle as this can cause the hinges to break.
4. Gently set the scale platform down to the floor.
5. Loosen the handles and unfold and set upright (handles shown in Figure 3-1).
6. Tighten the two hinges on the scale by rotating the two handles. This will secure the handrail mounted
indicator.
Figure 3-1. Secure the Handrail by Tightening the Durable Hinges
7. Screw in all four legs.
8. Attach the wrap around rails.
9. Tighten the hex screw head using the enclosed 6 mm Allen key to stabilize the scale.