Rice Lake Upper Body Single Frequency Composition Analyzer - D1000-2 - Pass Plus Software User Manual
Page 13
Advertising
Body Pass Plus Software Program — Body Pass Plus Software Installation
9
8. Press the
Finish
button on the screen shown below when the USB serial port software has been installed.
9. After the USB serial driver has been installed, the
Found New Hardware Wizard
is executed again and starts
installing the USB serial port driver. This may be repeated two to four times.
10. Once the installation is complete, go to the Start —> Setup —> Control Panel —> System —> Device
Manager —> List and press the
USB Serial Port (COM 3)
. The port number can be assigned another number.
Advertising
This manual is related to the following products: