Rice Lake Upper Body Single Frequency Composition Analyzer - D1000-2 - Pass Plus Software - Manual (Page 25)

Body Pass Plus Software Program — How to Use Body Pass Plus Software Program
21
2.4 Setting the Communication Port
Use the following steps to set the communication port between the Competitor Series body composition analyzer
and the Body Pass Plus software program.
1. Click on the Connect Port button in the menu buttons.
2. Click on the Port Scan button as shown below.
3. Available ports are searched and displayed.
4. Double-click the port connected with the body composition analyzer and CONNECTION OK appears.
5. Click the Apply button in the confirmation window for the chosen port. Click the OK button in the
confirmation window then the communication connection is completed. The Body Pass Plus shows the
state of applied communication port at the bottom right of the main screen.