Rice Lake Lift Truck/Pallet Jack Scales - Intercomp PW800 - Manual (Page 9)

PW800, Users
Rev O, January, 2008
9
TOTAL
This function is used to record an accumulated total. When you press the TOTAL key,
the weight that is to be added to the accumulated total will blink for about 5 seconds. To
add this to the total, press the TOTAL key again before the value stops blinking. The
accumulated total will be displayed for about 2 seconds and return to the previous
weighing mode.
If you just want to view the total, press and hold the TOTAL key for about 3 seconds.
The weight will be displayed until you release the key. To clear the accumulated total,
press the TOTAL and CLEAR keys simultaneously.
Note: You must clear the total before switching units or toggling NET/GROSS.
PEAK HOLD
The peak hold feature will remember the maximum weight applied. While in peak mode
it will not display any weight less than the maximum weight. To turn on the peak mode
press PEAK, to turn off the peak mode press PEAK again. The peak indicator will be
blinking if in peak mode. To clear the current peak weight, press the ZERO key.
Note: When you turn off the peak mode, the current peak weight will still be
remembered internally. This will show up if you then turn the peak mode back on.
Press ZERO while in peak mode (or turn the scale off) to clear the current peak
weight.
PRINT
If the scale is configured to demand output, pressing this key will print a ticket. NOTE:
The print ticket will be delayed any time a change in weight is detected. If there is
continuous motion for more than 20 or 30 seconds, the print request will be rejected and
the scale will return to normal weighing. Also see Serial Output section.
SET POINT 1
This is an optional feature that allows for an external set point. When the specified
weight (set point) is reached, a logic level high will be on the set point connection. Set
points are used with some other device (e.g. alarm, relay) in conjunction to the PW800.
To activate a set point, press the Set Point 1 (or Set Point 2) key. Enter the weight you
want the set point to activate.
SET POINT 2
Operates the same as Set Point 1.
I.D. #
User I.D. # is reserved for future use.
MODE
Reserved for future use.
OVER
Reserved for future use.