Test / zero, Left front, Right front – Rice Lake Intercomp SWII Portable Vehicle Scale User Manual
Page 7: Left rear, Right rear
SWII Users
Rev I, May 2009
Page 7 of 11
% / WGT
When pressed the display will show the selected weight percentage and the %
indicator will be “on”. This value is the weight percentage of the selected pads
vs. the total weight of the car. If a specific pad indicator is “on” it means that
weight is selected and will be added into the total and percentage shown.
A percentage will be displayed if no wheel weights are negative and the total
weight is not zero. If all four wheels are selected, the selected percentage will
read 100.0.
weight of the selected pads
selected % = ------------------------------------------- x 100
total weight of the car
TEST / ZERO
If pressed during normal weighing mode, the system will zero all four pads. To
zero a specified pad, press and hold the corresponding key (LF, RF, LR, RR)
and press zero. This key is also used to set calibration data (see SWII Service
Manual).
Normally, when the scale is turned on it will automatically zero the scale.
However, if the scale is turned off and turned back on within a couple of
seconds, the current weights will be remembered. That means that if a car is on
the weigh pads and the unit is turned 'off', when the scale is turned back 'on' the
current weights could be displayed, not zero.
LEFT FRONT
Toggles the selection of the left front pad. If the left front is selected, it will be
added to the total weight of the selected pads and the corresponding indicator
will be “on”. This will also add to the weight percentage of selected pads.
RIGHT FRONT
Toggles the selection of the right front pad. If the right front is selected, it will be
added to the total weight of the selected pads and the corresponding indicator
will be “on”. This will also add to the weight percentage of selected pads.
LEFT REAR
Toggles the selection of the left rear pad. If the left rear is selected, it will be
added to the total weight of the selected pads and the corresponding indicator
will be “on”. This will also add to the weight percentage of selected pads.
RIGHT REAR
Toggles the selection of the left rear pad. If the left rear is selected, it will be
added to the total weight of the selected pads and the corresponding indicator
will be “on”. This will also add to the weight percentage of selected pads.