Rice Lake Livestock Solutions - Contrast Control Installation for 920i Weighcenter - Manual (Page 2)

2 Contrast Control Potentiometer Installation
3. Insert the potentiometer into the hole and tighten down with 1/2
” wrench.
Ensure the white wire is oriented towards power switch as shown.
Figure 4. Install Contrast Control Potentiometer
4. To remove back plate, remove the screws securing the it to the indicator.
Figure 5. Remove Indicator Back Plate
5. Route the 8-pin connector cable through cord grip.
Figure 6. Route Wiring Through Cord Grip
Note
Power Switch
Contrast Control
Potentiometer
White wire towards
power switch
Remove all screws
Route Cable